Common rail injector tester High pressure AECR1000 High pressure

          Supports magnetic and piezo injectors, BOSCH, DENSO,DELPHI, PIZEO, CAT-L,CAT-H, Caterpillar）；

          Over current and short circuit protection

          Supports magnetic injector impedance measurement;

          On-board temperature sensor, overheat protection.

Included:

·         Electromagnetic injector end (2-pin)

·         Piezo injector end (4-pin)

·         Count switch terminal (3-pin)

Features:

A. A short press MODE button to switch to different injector conditions: Bosch, Denso, Delphi, ACT-L, CAT-H, Pizeo.

B, long press the MODE button to switch between test patterns and resistance injector test mode;

(Valid only in the injection stopped)

C，After entering the resistance test mode, connect the injector first, and press the ON/OFF button once. After 2 seconds, the resistance of the injector will be displayed on the screen. The unit is milliohm.

If it is found that the measured resistance deviates greatly from the actual resistance, it should be calibrated.

Calibration method: In the resistance measurement interface, directly short-circuit the two clips of the injector, and then short-press the “Counter” key. A “#” symbol will appear at the upper right of the screen. After this symbol disappears, calibration is completed.